2018 Nissan NV350 Urvan Remote Head Key 28268-C990E

Remote For Nissan:

FCC ID: CWTWB1U751
Part Numbers: H0561-C993A, 28268-JM70C, 28268-C990E
Brand: Nissan
Condition: Refurbished

Refurbished remotes and keys are factory original equipment components reconditioned with a brand new key, casing is either pre-owned or recased condition and may or may not include logo. They are fully tested and will function like their original equipment counterparts.

We test the remote and the transponder to ensure it will work before we send it to you. Battery and programming instructions are included. To make the remote work the keyless entry system, follow the instructions that come with the remote head key. To make the key work, have a local automotive locksmith cut the key and program the vehicle to start with the new transponder.

Programming Procedure:

IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again.

1. Close and lock all doors with the driver?? side power lock/unlock switch.
2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, system will not enter programming mode.
3. Insert key into the ignition cylinder and turn to the ACC position.
4. Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.
5. If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver?? side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).
6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver?? side power lock/unlock switch and open the driver side door.

The following vehicles can use this remote when equipped with the factory keyless entry system:

Nissan Cube (2009-2014), Nissan Juke (2011-2017), Nissan NV Van (2012-2018), Nissan Rogue (2008-2015), Nissan Versa (2012).